Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
egghead
Posts: 527
Registered: ‎05-07-2004
Message 1 of 2 (115 Views)

Skeletal Sketches and Copy

115 Views, 1 Replies
10-29-2012 08:15 AM

we very often create parts/assemblies using skeletal sketches, problem we encounter is that when we use the copy command in the components area on the ribbon.

 

The problem we have is that when we open the new assembly and components they are still looking at the original skeletal sketch. is there anyway to copy the orginal skeletal sketch to a new one and the new parts look at this upon using the copy.

 

At present what we do is make a copy and rename the original file. Then open the assembly and it looks for the original skeletal sketch, so we point it at the new skeletal sketch.

 

This is not an issue when we have a couple of parts in an assembly but if you have a lot of parts in the assembly it si very time consuming.

 

Distinguished Mentor
john.retzlaff
Posts: 919
Registered: ‎11-03-2003
Message 2 of 2 (109 Views)

Re: Skeletal Sketches and Copy

10-29-2012 09:23 AM in reply to: egghead

Design Assistant.

John Retzlaff
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.