Inventor General Discussion

Inventor General Discussion

Reply
New Member
2 Posts
0 Kudos
Registered: ‎01-28-2013
Post 1 of 3
Accepted Solution

simulation of bevel gears using contact rather than transitional constraints

357 Views, 2 Replies
01-28-2013 03:11 PM

Sorry if this is a very basic question but have been stuck on this for a few days now:  I'm trying to run a simulation of 2 bevel gears without using the transitional/rotation constraint, but using the contact between the surfaces to simulate the rotation of the gears - basically I have an L-shaped shaft running through both centers and want to have the upper gear grounded, make the lateral gear rotate around its own axis - the goal is simply to see the contact between the gears make the side gear rotate around the  vertical part of the l-shaped shaft, due to the contact forces.  I think I may need to review the definition of contact types, but not really sure what to do.  Any help is greatly appreciated.

Why not use the Rotational/Translation constraint?

Did you model the gears or are they Design Accelerator created?

The DA gears are approximations and probably won't work well with Contact Sets as they already interfer.

 

Attach your assembly here.

*Expert Elite*
28,632 Posts
2,129 Kudos
Registered: ‎04-20-2006
Post 2 of 3

Re: simulation of bevel gears using contact rather than transitional constraints

01-28-2013 03:14 PM in reply to: martinmmcd

Why not use the Rotational/Translation constraint?

Did you model the gears or are they Design Accelerator created?

The DA gears are approximations and probably won't work well with Contact Sets as they already interfer.

 

Attach your assembly here.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
New Member
2 Posts
0 Kudos
Registered: ‎01-28-2013
Post 3 of 3

Re: simulation of bevel gears using contact rather than transitional constraints

01-28-2013 03:25 PM in reply to: JDMather

Hi JD,

 

thanks for the reply - that makes sense, there's just too much interference, I'll see if I can't get the same result using the constraints.

 

Martin

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are you interested in helping shape the future of the Autodesk Community? To participate in this brief usability study, please click here. Your time and input is greatly appreciated!