Inventor General Discussion

Inventor General Discussion

Reply
Active Member
241victor
Posts: 7
Registered: ‎01-31-2012
Message 11 of 13 (96 Views)

Re: Simple problem dynamic simulation

04-10-2012 02:02 AM in reply to: 241victor

Up

*Expert Elite*
JDMather
Posts: 27,481
Registered: ‎04-20-2006
Message 12 of 13 (90 Views)

Re: Simple problem dynamic simulation

04-10-2012 05:29 AM in reply to: 241victor

I haven't opened your second attachment yet (I don't have rar extractor) but did you use a Spatial joint and 3D Contact  joint?

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Active Member
241victor
Posts: 7
Registered: ‎01-31-2012
Message 13 of 13 (69 Views)

Re: Simple problem dynamic simulation

04-11-2012 03:47 AM in reply to: JDMather

Hi

 

Yes we use them. We have simulate this:

http://www.youtube.com/watch?v=PBdGvAmWKzs

But we don't konw how to put the piece into the container in an horizontal position, and then, move it around the table. We need help, in this issue, we hope that you can help us.
I think that if we make impenetrable the rotary table we should be able to move the piece arround the table
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.