Inventor General Discussion

Inventor General Discussion

Reply
Active Member
jd.gomez242
Posts: 8
Registered: ‎03-21-2012
Message 1 of 1 (63 Views)

Silent Operation not working on Dynamic Simulation

63 Views, 0 Replies
05-13-2012 11:17 PM

Hello

 

I'm trying to use VBA to stop all messages from popping up while I run the simulation. I'm setting thisApplication.SilentOperation=True. But when I try to run the simulation I keep getting the message:

"The mechanism has locked degrees of freedom or bounds, which could be in conflict with imposed motion. Some joints may not function correctly."

 

Is there any way around this? 

How can I create a handle to dismiss this message?

 

Thanks

 

Juan Diego Gómez

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.