Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
sps_cad_guy
Posts: 137
Registered: ‎08-22-2012
Message 1 of 3 (306 Views)
Accepted Solution

Showing tangent lines

306 Views, 2 Replies
10-12-2012 08:20 AM

I've gone through a search, and scanned over the help file, and can not find this mentioned.

In my drawing, of either a part or an assembly, how do I display tangent lines?

Thank you, in advance, for your help.

Lenovo Think Pad
Windows 7 SP 1
64 Bit.
Inventor 2013
ACAD Mechanical 2013

You need to select the Edit View, then on the Dispay Options is the Tangent Edges

*Expert Elite*
blair
Posts: 4,229
Registered: ‎11-13-2006
Message 2 of 3 (304 Views)

Re: Showing tangent lines

10-12-2012 08:23 AM in reply to: sps_cad_guy

You need to select the Edit View, then on the Dispay Options is the Tangent Edges

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 340.52
SpacePilot Pro 3.17.7, 6.17., 4.11
Delta Tau Chi ΔΤΧ
Distinguished Contributor
sps_cad_guy
Posts: 137
Registered: ‎08-22-2012
Message 3 of 3 (300 Views)

Re: Showing tangent lines

10-12-2012 08:25 AM in reply to: blair

Thank you very much!

I looked for like 45 minutes for this.

Lenovo Think Pad
Windows 7 SP 1
64 Bit.
Inventor 2013
ACAD Mechanical 2013
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.