shell

[tborland]

Please see Shell 2 .. it shells out but how do i have the Shell to the curved face on Revolution 1.I want the Shell to cut through Extrusion 1 and to the Revolution 1 curved face

Regards

Tony

[JDMather]

Shell works on entire solid body.

You have two solid bodies.

You will have to Extrude Cut between the two.  (you might Combine first, depending on design intent)

[tborland]

I combined both solids and then made the cut.The cut out created is what i required but now i cannot get the fillet to work....Any thoughts on how to get the fillet-4 on the end to remove not add

Regards

Tony

[JDMather]

Your logic doesn't make sense to me.
I think those fillets should be added before combine and I don't understand why you couldn't use shell?

Slice that feature in half and look at the wall thickness.
Shouldn't there be a fillet on inside as well?

[tborland]

That is why i asked for help.Why do you not post how you would accomplish this then

Yes you are correct  there should be a fillet on the inside....just did not get to that point yet as i was not sure if the correct flow path is being used

Thanks anyway

Tony

[tborland]

JD,Unless i have misunderstood you ,you mentioned extrude cut in your first post

Thanks

[JDMather]

---

@tborland wrote:

That is why i asked for help.Why do you not post how you would accomplish this then

Tony

---

As I stated - I don't understand your design intent, but maybe this is something close to what you are after (see attached)?

Is Extrude Cut 4 in my example what you are after?

Hmm, tried to attach 3 times and don't see the attachment.

Finally worked with Chrome but not with IE.

[tborland]

That is what i want except i do not want it to cut into Revolution 1 wall

Thanks

[JDMather · Accepted solution]

Then delete it, or maybe you want to Offset Surface 2mm or something and Extrude To the surface?

[tborland]

Thanks JD

Thats what i was after.Appreciated

Now i use the Circular pattern and it errors when i select the delete face...if i do not use the delete face in circular pattern it works

Thanks

[tborland]

The circular pattern i got work

Thanks for your help

Tony