sheetmetal creation using loft and shell

[Anonymous]

I am trying to unfold a part which I think would be easier to create by
making a solid which will be created by lofting two profiles then creating a
shell to get a sheetmetal like part and I then want to unfold it. Can I do
this? If not how would you create a sheet metal part of a square to round
transition where the square face and round face lie on different planes.
Any help would be appreciated

Thanks
shane

[Anonymous]

Go to Drew's site and there is a solution there, I am told.
http://www.mymcad.com
Look at the post below yours Sean's FAQ and find links to lots of sites with
oodles of examples and help.


--
Laurence,

Power is nothing without Control
---


"shane tan" wrote in message
news:333752317FE5EF1C7ED6FD3707063102@in.WebX.maYIadrTaRb...
> I am trying to unfold a part which I think would be easier to create by
> making a solid which will be created by lofting two profiles then creating
a
> shell to get a sheetmetal like part and I then want to unfold it. Can I do
> this? If not how would you create a sheet metal part of a square to round
> transition where the square face and round face lie on different planes.
> Any help would be appreciated
>
> Thanks
> shane
>
>