Hi! I would like to automate my drawings a little but further than it already is.
I would like to know how to add the name of the sheet metal rule used in my drawings.
For example, in these rules, I have "11 GA" "14 GA" "SS 11 GA" and "SS 14 GA", etc...
I would like to be able to add this name to my drawing when I create it. How can I achieve this?
i have attached a picture showing what I would like to add to my drawings.
Thanks a lot guys!
Nevermind I have found it, I created a variable named "TypeMaterial" and entered this equation "=<Sheet Metal Rule>"
Now, what I would need is to be able to show it only when the model used is a sheet metal.
Is it possible? If so, how can I achieve this? (I would prefer without iLogic, but if this isn't possible I will go with iLogic)
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!