Inventor General Discussion

Reply
Distinguished Mentor
rdyson
Posts: 897
Registered: ‎04-11-2005
Message 11 of 15 (156 Views)

Re: Sheet metal Problem

11-12-2012 07:59 AM in reply to: JDMather

Here's my attempt, at least the first half. Not perfect, but might be close enough after some tweaking.

*Expert Elite*
JDMather
Posts: 27,024
Registered: ‎04-20-2006
Message 12 of 15 (138 Views)

Re: Sheet metal Problem

11-12-2012 03:26 PM in reply to: aaddekrom

I worked out a solution today.  I will post it tomorrow if I remember.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
*Expert Elite*
JDMather
Posts: 27,024
Registered: ‎04-20-2006
Message 13 of 15 (132 Views)

Re: Sheet metal Problem

11-12-2012 07:06 PM in reply to: JDMather

I could not find a way other than face-by-face.

The attached was done in student version - so examine the technique and then delete.

Pull down the red End of Part marker step by step.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Contributor
aaddekrom
Posts: 18
Registered: ‎02-18-2011
Message 14 of 15 (124 Views)

Re: Sheet metal Problem

11-12-2012 11:57 PM in reply to: JDMather

This is great ! Just faces.

Thank you very much.

Contributor
aaddekrom
Posts: 18
Registered: ‎02-18-2011
Message 15 of 15 (120 Views)

Re: Sheet metal Problem

11-13-2012 12:11 AM in reply to: rdyson

Thanks for your help, it looks ok, but JDMathers solution is more straightforward.

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.