Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Mentor
924 Posts
139 Kudos
Registered: ‎04-11-2005
Post 11 of 15

Re: Sheet metal Problem

11-12-2012 07:59 AM in reply to: JDMather

Here's my attempt, at least the first half. Not perfect, but might be close enough after some tweaking.

*Expert Elite*
28,655 Posts
2,129 Kudos
Registered: ‎04-20-2006
Post 12 of 15

Re: Sheet metal Problem

11-12-2012 03:26 PM in reply to: aaddekrom

I worked out a solution today.  I will post it tomorrow if I remember.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
*Expert Elite*
28,655 Posts
2,129 Kudos
Registered: ‎04-20-2006
Post 13 of 15

Re: Sheet metal Problem

11-12-2012 07:06 PM in reply to: JDMather

I could not find a way other than face-by-face.

The attached was done in student version - so examine the technique and then delete.

Pull down the red End of Part marker step by step.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Contributor
18 Posts
8 Kudos
Registered: ‎02-18-2011
Post 14 of 15

Re: Sheet metal Problem

11-12-2012 11:57 PM in reply to: JDMather

This is great ! Just faces.

Thank you very much.

Contributor
18 Posts
8 Kudos
Registered: ‎02-18-2011
Post 15 of 15

Re: Sheet metal Problem

11-13-2012 12:11 AM in reply to: rdyson

Thanks for your help, it looks ok, but JDMathers solution is more straightforward.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are you interested in helping shape the future of the Autodesk Community? To participate in this brief usability study, please click here. Your time and input is greatly appreciated!