How do i make the attach file as a sheet metal part?It takes a lot of moves to make as solid part..can it be made in sheet metal?
Solved! Go to Solution.
Solved! by japike. See the answer in context.
Yup, looks good except sketch8 needs to be fully constrained.
You should be able to make this as a sheetmetal part. Start in the sheetmetal environment and instead of using extrude as your first feature, use the face tool. Instead of extrusion 2, use a cut. You could also use the face tool with the bend option to replace extrusions 5 & 6. Give it a try. When you get stuck, post what you've accomplished here and someone will help you out.
I got to this point to sheet metal part.What steps should i now take to complete the rest of the part?
I am not sure how to create the sections which are bent
Through your technique i made the next step but need help adding the last part to this.
CAn this when finished be flattened
Appreciated your help
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!