Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
JimSteinmeyer
Posts: 326
Registered: ‎05-16-2011
Message 1 of 3 (176 Views)
Accepted Solution

Sheet Metal Flange only on partial edge

176 Views, 2 Replies
12-14-2012 11:26 AM

I have a sheet metal part where I selected an incorrect edge when creating flanges, is there an easy way to deselect the edge? I can add edges and I can select the glyph for a specific edge to edit it, but short of deleating the feature and starting over I have not found a good way of deselecting an edge.

 

thank you

Jim

Inventor Premium 2013 SP1.1
Vault 2013- plain vanilla version
HP G71 notebook
celeron cpu w\ 4gb RAM and 64 bit system
Win 7 home premium

Ya, my boss has me running my personal machine at work.

You should be able to edit the flange and press the ctrl key while selecting the highlighted edge of the flange you want to delete.

Valued Mentor
japike
Posts: 322
Registered: ‎02-06-2004
Message 2 of 3 (171 Views)

Re: Sheet Metal Flange only on partial edge

12-14-2012 11:41 AM in reply to: JimSteinmeyer

You should be able to edit the flange and press the ctrl key while selecting the highlighted edge of the flange you want to delete.

Peace,
Jeff
Inventor 2013
Distinguished Contributor
JimSteinmeyer
Posts: 326
Registered: ‎05-16-2011
Message 3 of 3 (164 Views)

Re: Sheet Metal Flange only on partial edge

12-14-2012 11:51 AM in reply to: japike

That was the answer! I neglected to use the control button.

 

Thank you

Jim

Inventor Premium 2013 SP1.1
Vault 2013- plain vanilla version
HP G71 notebook
celeron cpu w\ 4gb RAM and 64 bit system
Win 7 home premium

Ya, my boss has me running my personal machine at work.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.