Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
j_berry
Posts: 68
Registered: ‎11-15-2012
Message 1 of 2 (974 Views)
Accepted Solution

Sheet Metal Flange only on partial edge

974 Views, 1 Replies
12-14-2012 06:25 AM

How can I define the length of a flange in a sheet metal part? In other words, I would like a flange to run a definitive length along the edge of a part, not the entire edge of a part.

 

I apologize if this has been asked before. I did a brief search of the forum and could not find a solution.

Attach your file here.

 

Expand the dialog box and set Width or desired Offset distance from each end.

 

FLANGE.png

*Expert Elite*
JDMather
Posts: 27,977
Registered: ‎04-20-2006
Message 2 of 2 (971 Views)

Re: Sheet Metal Flange only on partial edge

12-14-2012 06:27 AM in reply to: j_berry

Attach your file here.

 

Expand the dialog box and set Width or desired Offset distance from each end.

 

FLANGE.png

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!