I know this is elementary, but I'm having problems forming this part up to get a flat for the sheet lasers.
What would be the best way to start this part?
Thank you for your help.
Solved! Go to Solution.
Solved by mrattray. Go to Solution.
I made a similar part recently. This is how I did it. There may be better ways.
If you attach your ipt attempt here we could figure out what you did wrong.
Not sure if there's an easier way or not, but that works perfectly.
Thank you very much for the useful help.
I can not see Mike's part but here is my version of it for you. IV 2010.
Regards,
Igor.
@sps_cad_guy wrote:I know this is elementary, but I'm having problems forming this part up to get a flat for the sheet lasers.
What would be the best way to start this part?
Thank you for your help.