Community
I'm sure this has been asked before: How can I get Sheet Metal Width and Length to show up as fractions? Thanks Mike
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
---------
Mike Davis
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
---------
Mike Davis
Hello,
Thank you very much take note that this post is a duplicate of this one:
http://forums.autodesk.com/t5/Inventor-General/Sheet-Metal-Dim-Help-Decimal-to-Fraction/m-p/4759759#
Many Thanks
Best Regards
Nicolas Bourquin
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")