Inventor General Discussion

Inventor General Discussion

Message 1 of 3 (63 Views)

Service Pak????

63 Views, 2 Replies
11-13-2002 02:51 AM
Where is it autodesk!
some of this (EDITED) is really getting to me.
Message 2 of 3 (63 Views)

Re: Service Pak????

11-13-2002 02:56 AM in reply to: *Jesse
just seen the thread. hope you're right. Some of this stuff is just the
Like i use 3d Studio Viz 3i quite frequently. and when i import an iam. The
parts numbers in the selection dialogue box only show one character so if i
have 500 parts in my assembly that start with the number 0 as a filename
(012313.ipt). then the selection box only shows 500 0's. Try figureing out
which is which then.
*Pawelski, Andrew
Message 3 of 3 (63 Views)


11-13-2002 03:23 AM in reply to: *Jesse
Argggh! I just noticed that. I'm bringing IV6 data into 3ds max 5. 2800+
components all named '7' after import - that's it. I feel your pain, I just
hope Autodesk knows about this to address it. This is huge problem for me,
this did not happen with 5.3, the only bug that 5.3 had was the component
pattern problem - which I haven't experimented with in 6 yet.


Andrew Pawelski
Valiant Machine & Tool
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.