Inventor General Discussion

Reply
*Jesse
Message 1 of 3 (62 Views)

Service Pak????

62 Views, 2 Replies
11-13-2002 02:51 AM
Where is it autodesk!
some of this (EDITED) is really getting to me.
*Jesse
Message 2 of 3 (62 Views)

Re: Service Pak????

11-13-2002 02:56 AM in reply to: *Jesse
just seen the thread. hope you're right. Some of this stuff is just the
(edited)
Like i use 3d Studio Viz 3i quite frequently. and when i import an iam. The
parts numbers in the selection dialogue box only show one character so if i
have 500 parts in my assembly that start with the number 0 as a filename
(012313.ipt). then the selection box only shows 500 0's. Try figureing out
which is which then.
later
*Pawelski, Andrew
Message 3 of 3 (62 Views)

Re:

11-13-2002 03:23 AM in reply to: *Jesse
Argggh! I just noticed that. I'm bringing IV6 data into 3ds max 5. 2800+
components all named '7' after import - that's it. I feel your pain, I just
hope Autodesk knows about this to address it. This is huge problem for me,
this did not happen with 5.3, the only bug that 5.3 had was the component
pattern problem - which I haven't experimented with in 6 yet.

Autodesk?

Andrew Pawelski
Valiant Machine & Tool
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.