Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
PaulB108
Posts: 160
Registered: ‎05-05-2009
Message 1 of 2 (106 Views)

Sending assembly to 3rd party - easiest way to do this?

106 Views, 1 Replies
11-25-2013 12:48 PM

 

Hello,

 

I have an assembly I wish to forward to a contractor. It is only small - containing some basic FEA (213 KB). What is the easiest, most effective way to do this? Pack and Go?

 

Obviously I have never done it before...

 

 

Regards Paul.

Inventor Professional 2014.
Windows 7 64 bit.
*Expert Elite*
blair
Posts: 4,494
Registered: ‎11-13-2006
Message 2 of 2 (100 Views)

Re: Sending assembly to 3rd party - easiest way to do this?

11-25-2013 01:17 PM in reply to: PaulB108
If they are on the same version of Inventor, then the Pack-And-Go will work fine. If they don't have Inventor you may want to have a conversation with their CAD person as to what works for them as well. If they aren't on Inventor, good chance that the FEA data will be lost in conversion to different systems as the FEA data is very specific to CAD versions.
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 344.75
SpacePilot Pro 10.2.0 / 17.2.0.11011 / 4.17
Delta Tau Chi ΔΤΧ
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.