Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
Infoseeker
Posts: 195
Registered: ‎03-15-2012
Message 1 of 1 (132 Views)

Selection tool, Inventor 2013, what happened.

132 Views, 0 Replies
01-11-2013 02:47 PM

What happened to the selection tool, one that allowed you pick f.e. one line that was sitting on the top of the other by hoovering and highligting them? What is that "curve" selection thing that replaced it? Geez...

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.