Inventor General Discussion

Inventor General Discussion

Posts: 699
Registered: ‎04-26-2006
Message 1 of 2 (204 Views)

Section view won't work w/ view reps.

204 Views, 1 Replies
12-20-2012 11:04 AM

I have a model that I want to show a top view that is cropped and then show a section cut from that view.  I need to shut off the ceiling in the top view but I want to show the ceiling in the section view.  I've set up view reps of OVHD-ON/OFF.  When I crop the original, do a section cut, and then manually turn off the visibility of the overhead it works fine.  It only sections the area that was cropped and the view shows a sectioned ceiling.  The problem is when I want to set up a view rep for the space.  When I use the view rep then the overhead shows in the section view past the crop line.  What gives?


On the attached picture you'll see what the section view looks like after I manually turn off the OVHD visibility on the left (what I want) and the right shows what happens when I use the view representations.. 

Product Support
Posts: 1,114
Registered: ‎11-22-2011
Message 2 of 2 (171 Views)

Re: Section view won't work w/ view reps.

12-21-2012 04:06 PM in reply to: jpblower

Do you have the associative box checked for the drawing views? It's the radio box with a chain icon in the top right hand area of Design Views in the Edit View dialogue. 


Are you manually a value into the Margins field of the Edit Drawing View > Model State tab?


Another feature that may help is the Tools > Documents Settings > Modeling Tab > Participate in Assembly and Drawing Section option. 




Nathan Chandler

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.