Section view make cut part disappear

[Anonymous]

Hello!

I have a big assembly of a scanner and in my drawing i've made a section view and in that section view, the part that are cut disappeared. 

I have to do a section view precisely to annotate the position of the part that are cut... Do you know how i could keep the cut part in my section viewe?

Thanks in advance 

[JDMather]

What version of Inventor?
Service Pack?

Graphics card/Driver?

What if you go to Tools>Application Options>Hardware tab and set to Software Graphics?

[bob_holland]

RenaudCharles,

Welcome to the forum.

Can you please check to mack sure that your part is set to participate in the section view.

Here are a couple of link that will guide your through the process:

http://knowledge.autodesk.com/support/inventor-products/learn-explore/caas/CloudHelp/cloudhelp/2015/...

https://www.youtube.com/watch?v=wV7XqzjaRIw

Please send us an update after you have had a chance to review the information above.

Thank you.

[Anonymous]

Hello, 

The part that disapeared are not in my browser, so i cant check if they are in section representation or slice.

Do you have an idea how i could make them appear in my browser?

[Anonymous]

Finally, i could make the cut parts appear if i clicked the whole assembly and select ''none'' in the section participation. Though, if i selct a part and switch its section participation from ''none'' to ''section'' it will disappear.The problem is that I want to show the middle of the part and i can't do it when selection participation is on none. Any ideas how to fix this problem?

[Anonymous]

I just realised that this problem also occurs when i do a detail view...

[bob_holland]

RenaudCharles,

Is this a Multi-Part Assembly or a Multi-Body Part?

Thank you.

[Anonymous]

This assembly is a multi-part assembly