Hi, Jason;
I am sorry I couldn't get back to you earlier. I have managed somehow to fix
the problematic file. In the assembly file I have replaced one component and
saved the assembly. Open a drawing file and generated section view. Saved
the file, go back to the assembly, replace the component to what I needed,
save and close. Open the drawing - section view updated properly.
I could send you the file, but, first of all, it is of a substantial size
(and I am still on a slow connection). And secondly, this very file is OK
now, so I am not sure if you want to look at it?
Anyway, thank you for your interest!
Best regards,
Igor.
--
To reply please use igor@iinet.net.au address
"Jason Ruge (Autodesk)" wrote in message
news:5080451@discussion.autodesk.com...
Hi Igor,
Can you please post this data set so we can take a look at what's going on
here?
--
-Jason
Inventor QA