Community
style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
"davejan" <davejan@snet.net>good
wrote in message
href="news:f127302.1@WebX.maYIadrTaRb">news:f127302.1@WebX.maYIadrTaRb...
point, I'll give it a try..
I wonder why IV couldnt section it? The solid
seemed fine. I wonder, does anyone else see the screwed up section lines in my
example, like it cannot find the boundry. It might have something to do with
sectioning fillets, or my graphics card.
Thanks,
David
style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
"davejan" <davejan@snet.net>I
wrote in message
href="news:f127302.-1@WebX.maYIadrTaRb">news:f127302.-1@WebX.maYIadrTaRb...
posted in CF, I have an shelled tube open on one end that I drew in IV6 sp1.
the other end is thickened and then I gave it a full radius. I cannot get the
section lines in the idw to show up right.. any suggestions as to the correct
way to draw? anyone else have this problem? I'm using an oxygen VX1, is it
graphics related?
Thanks,
David
style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
"davejan" <davejan@snet.net>I
wrote in message
href="news:f127302.10@WebX.maYIadrTaRb">news:f127302.10@WebX.maYIadrTaRb...
am using sp1, I do not remember seeing this before sp1, but then again I only
did a few drawings.. anyone without sp1 able to tell me if the sections are
screwed up at large scales as well? I'll go back.. i wasn't having that many
problems before sp-1, I cant send customers drawings that are screwed like
this.