Inventor General Discussion

Reply
Valued Contributor
knaveenpai
Posts: 57
Registered: ‎07-16-2007
Message 1 of 3 (270 Views)
Accepted Solution

screw load

270 Views, 2 Replies
04-17-2011 10:35 PM

Hi Everyone,

I have a problem for you guys where in I need help.

I have two plates bolted  together with M10 socked headed cap screw. In which the top plate is countrebored and relived, the bottom plate is tapped for M10.

I want to check how much load can the screw withstand.

how can i do this in Inventor analysis.

or is there any other way to calculate this

 

 

thanks for ur help

 

regards

Naveen

Hi knaveenpal,

 

You can use the Calculation tab of the Bolted Connection tool to do this:

http://inventortrenches.blogspot.com/2011/04/bolt-and-screw-calculations-with-bolted.html

 

 

I hope this helps.

Best of luck to you in all of your Inventor pursuits,

Curtis

http://inventortrenches.blogspot.com/

 

 

 

 

 

*Expert Elite*
Curtis_Waguespack
Posts: 2,930
Registered: ‎03-08-2006
Message 2 of 3 (235 Views)

Re: screw load

04-18-2011 09:52 AM in reply to: knaveenpai

Hi knaveenpal,

 

You can use the Calculation tab of the Bolted Connection tool to do this:

http://inventortrenches.blogspot.com/2011/04/bolt-and-screw-calculations-with-bolted.html

 

 

I hope this helps.

Best of luck to you in all of your Inventor pursuits,

Curtis

http://inventortrenches.blogspot.com/

 

 

 

 

 



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Valued Contributor
knaveenpai
Posts: 57
Registered: ‎07-16-2007
Message 3 of 3 (200 Views)

Re: screw load

04-18-2011 03:47 PM in reply to: Curtis_Waguespack

Hi  Curtis,

 

thanks for your help

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.