Inventor General Discussion

Inventor General Discussion

Reply
Contributor
gsger5
Posts: 14
Registered: ‎01-25-2013
Message 1 of 3 (234 Views)
Accepted Solution

Scaling a part up?

234 Views, 2 Replies
01-28-2013 02:48 PM

I need to scale a part up by a ration on 2, but I'm not sure how?

Derive Component and select Scale.

*Expert Elite*
JDMather
Posts: 28,251
Registered: ‎04-20-2006
Message 2 of 3 (231 Views)

Re: Scaling a part up?

01-28-2013 02:55 PM in reply to: gsger5

Derive Component and select Scale.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Active Member
palmhat
Posts: 8
Registered: ‎04-12-2012
Message 3 of 3 (140 Views)

Re: Scaling a part up?

04-19-2013 10:49 AM in reply to: JDMather

GREAT, THX AGAIN!

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.