Inventor General Discussion

Reply
Member
thomashacked
Posts: 3
Registered: ‎04-06-2012
Message 1 of 4 (895 Views)
Accepted Solution

Scale object

895 Views, 3 Replies
04-06-2012 02:48 AM

Hi I made the mistake that I came to measure my object as cm but inventor writes it's in as mm, is there a way where I can scale objectet up giving it the right size

You can go through your Parameters and change all of the dimensions or Derive Component with Scale.
Can you attach the file here?

*Expert Elite*
JDMather
Posts: 27,045
Registered: ‎04-20-2006
Message 2 of 4 (879 Views)

Re: Scale object

04-06-2012 04:57 AM in reply to: thomashacked

You can go through your Parameters and change all of the dimensions or Derive Component with Scale.
Can you attach the file here?

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Member
thomashacked
Posts: 3
Registered: ‎04-06-2012
Message 3 of 4 (873 Views)

Re: Scale object

04-06-2012 05:39 AM in reply to: JDMather

Yea here is the object there is two small objects

 

and thanks for the help so far

Member
thomashacked
Posts: 3
Registered: ‎04-06-2012
Message 4 of 4 (872 Views)

Re: Scale object

04-06-2012 05:42 AM in reply to: thomashacked

here is the other

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.