Inventor General Discussion

Reply
New Member
guneskupelioglu
Posts: 1
Registered: ‎01-05-2013
Message 1 of 2 (151 Views)

Scale a part

151 Views, 1 Replies
01-06-2013 02:36 AM

Hello, I am a new inventor user. I made several parts but I made their dimensions wrong. For example instead of 62mm I made 6,2 mm. I want to scale them but after scaling I want to use them like an original part. I want to change the dimensions when needed. Is it possible? In the forum I read that deriving a part is solution but hot it works? I didn't understand exactly. Thank You

*Expert Elite*
JDMather
Posts: 27,504
Registered: ‎04-20-2006
Message 2 of 2 (133 Views)

Re: Scale a part

01-06-2013 07:06 AM in reply to: guneskupelioglu

guneskupelioglu wrote:

Hello, I am a new inventor user.


 

I recommend that you simply do the parts over from scratch (and correctly this time).
Almost every part I have ever made - I did at least two attempts and often many many more than two.

The experience will be good and it won't be nearly as much work as you might think.

 

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.