Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
tmulligan
Posts: 39
Registered: ‎02-18-2012
Message 1 of 2 (280 Views)

saving ipt file message

280 Views, 1 Replies
03-08-2012 10:56 AM

I get this every time i try to close an .ipt.

The current operation requires data from docuemt {location on my network{ but it cannot be found.

 

Regards,

Tom

Product Support
dave.anderson
Posts: 193
Registered: ‎10-25-2006
Message 2 of 2 (243 Views)

Re: saving ipt file message

04-06-2012 07:42 AM in reply to: tmulligan

It sounds like you may have a permissions issue or invalid paths. Check your Inventor Project file and verify that all the locations defined in your project file are valid and that you have proper permissions to them.



Dave Anderson
Premium Support Analyst – DLS Mechanical Design
Autodesk, Inc.


If I have answered your question, please "Accept Solution" so others may benefit as well.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.