Inventor General Discussion

Reply
*Expert Elite*
CelticDesignServices
Posts: 517
Registered: ‎11-29-2011
Message 1 of 2 (111 Views)
Accepted Solution

Saving an Animation

111 Views, 1 Replies
11-25-2013 11:46 AM

A simple question so one would think but I'm failing to find the answer still.

 

But why is it that I can only seem to save an animation in Inventor Studio (2014) as a .wmv (or Windows Media File)?

Shouldn't I have the options for saving it as other types such as an .avi or the like?

I could have sworn I was able to in past releases.....

The tuitorials say I should be able to save it as such, so where oh where is the setting that is dictating this?

 

Note: This animation is a cross section, not a shaded, realistic type with lighting and camera details to worry about.

 

In the mean time I'll keep looking and post what I find if anything here.

 

New EE Logo.PNG


Inventor.PNG     vault.PNG



Jim
Celtic Design Services, LLC

Inventor/AutoCAD/Vault WorkGroups
Always for hire - celticdesign01ATyahooDOTcom
https://www.facebook.com/pages/Celtic-Design-Services-LLC/184666001666426
==========================================================
Please use the "Accept as Solution" and "Give Kudos" functions as appropriate to further enhance the value of these forums.

Go raibh maith agat (in other words...Thank you!)

FOUND IT....Duh.

 

Silly placement for this but one has to select the "navigate" button next to the file path on the "output" tab.

There a window will pop up and there under the "Save as type" selection will be.

 

Ugh

 

*Expert Elite*
CelticDesignServices
Posts: 517
Registered: ‎11-29-2011
Message 2 of 2 (107 Views)

Re: Saving an Animation

11-25-2013 12:21 PM in reply to: CelticDesignServices

FOUND IT....Duh.

 

Silly placement for this but one has to select the "navigate" button next to the file path on the "output" tab.

There a window will pop up and there under the "Save as type" selection will be.

 

Ugh

 

New EE Logo.PNG


Inventor.PNG     vault.PNG



Jim
Celtic Design Services, LLC

Inventor/AutoCAD/Vault WorkGroups
Always for hire - celticdesign01ATyahooDOTcom
https://www.facebook.com/pages/Celtic-Design-Services-LLC/184666001666426
==========================================================
Please use the "Accept as Solution" and "Give Kudos" functions as appropriate to further enhance the value of these forums.

Go raibh maith agat (in other words...Thank you!)
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.