Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Sample "Frame Generator" part required

5 REPLIES 5
Reply
Message 1 of 6
isocam
214 Views, 5 Replies

Sample "Frame Generator" part required

Can anybody help???

 

Does anybody have a Inventor part that has been created using "Frame Generator"?

 

I need it to test a VBA project of mine.

 

The more complex the better!!!!

 

Many thanks in advance.

 

Darren

5 REPLIES 5
Message 2 of 6
cbenner
in reply to: isocam
Message 3 of 6
isocam
in reply to: cbenner

Many thanks for your reply!!!

 

My email address is

 

d.j.smith@aim.com

 

Thanks

 

Darren

 

Message 4 of 6
Curtis_Waguespack
in reply to: isocam

Hi isocam,

 

You can find some sample files at this link:

http://knowledge.autodesk.com/support/inventor-products/downloads/caas/downloads/content/inventor-sa...

 

Once downloaded, you should find a Frame Generator assembly at:

...Inventor 20xx\Samples\Models\Weldments\Carriage

where 20xx equals the version of Inventor.

 

With that in mind, if you're just needing a part file that was generated from Frame Generator, attached are a few. Note that I didn't see your Inventor version listed, so the attached files are from Inventor 2010, which is the oldest version I still have at this point.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com

Message 6 of 6
isocam
in reply to: cbenner

Part if possible

Regards

Darren

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report