Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Ribs

2 REPLIES 2
Reply
Message 1 of 3
damian__s
218 Views, 2 Replies

Ribs

Can the RIB tool be used on the part (2014) where the sketches are placed?

 

These will be used for strength or do i have to use Extrusion Tool?

 

Thanks

 

Damian

2 REPLIES 2
Message 2 of 3
CCarreiras
in reply to: damian__s

Hi!

 

You can't use Rib because this tool project the profile in only one linear direction.

 

In my opinion, i use revolve in the cylinder and extrude (or sweep) in the top.

 

Did you find this reply helpful ? If so, use the  Mark Solutions!  Accept as Solution or Give Kudos!Kudos - Thank you!



Regards.
CCarreiras
Message 3 of 3
damian__s
in reply to: CCarreiras

Thank you...I thought that would be the case but i check first

 

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report