Inventor General Discussion

Inventor General Discussion

Reply
Member
4 Posts
0 Kudos
Registered: ‎01-11-2013
Post 1 of 3
Accepted Solution

Revolving- Need help

157 Views, 2 Replies
01-11-2013 08:57 AM

How can I revolve the top section to blend into the bottom section

I left out two circles in Revolution3, but you should be able to figure it out from this.

*Expert Elite*
28,598 Posts
2,122 Kudos
Registered: ‎04-20-2006
Post 2 of 3

Re: Revolving- Need help

01-11-2013 09:29 AM in reply to: lahink

I left out two circles in Revolution3, but you should be able to figure it out from this.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Member
4 Posts
0 Kudos
Registered: ‎01-11-2013
Post 3 of 3

Re: Revolving- Need help

01-11-2013 09:36 AM in reply to: JDMather

This works out perfect.  Thank you very much.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post