Inventor General Discussion

Inventor General Discussion

Reply
Member
lahink
Posts: 4
Registered: ‎01-11-2013
Message 1 of 3 (152 Views)
Accepted Solution

Revolving- Need help

152 Views, 2 Replies
01-11-2013 08:57 AM

How can I revolve the top section to blend into the bottom section

I left out two circles in Revolution3, but you should be able to figure it out from this.

*Expert Elite*
JDMather
Posts: 28,200
Registered: ‎04-20-2006
Message 2 of 3 (146 Views)

Re: Revolving- Need help

01-11-2013 09:29 AM in reply to: lahink

I left out two circles in Revolution3, but you should be able to figure it out from this.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Member
lahink
Posts: 4
Registered: ‎01-11-2013
Message 3 of 3 (140 Views)

Re: Revolving- Need help

01-11-2013 09:36 AM in reply to: JDMather

This works out perfect.  Thank you very much.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.