Anyone ever heard of a Ø1 5/8 x 5.5tpi thread?
Its not in my Mach Handbook, but the vendor has supplied a nut with this thread. I made the bolts with a 1 5/8-6 thread. Of coarse, the nut will not thread onto the bolt.
The vendor is telling me that the Ø1 5/8-5.5 is an "industry standard". lol
Anyone else ran into this before?
Never seen that one, I googled it and this is the closest I came.... still not sure how it's a "standard".
1.625 x 5.5 pitch is standard UNC/USS
12 TPI is UNF
Wow, Machinery Handbook does not have that for 1 5/8, but it does have a 1 5/8-24 UNS, which you link shows as N/A. Might be time for a new Machinery Handbook?
1-5/8 is not in MANY of the thread charts.. Most have 1.5 then 1.75 skipping right over the 1.625
There is NO 1 5/8 UNC or UNF according to my Machinery Handbook (25th ed, pg 1667). There are a few other UNS (which denotes special), but no 5.5 is listed.
I guess they can make them whatever they want as long as they call them UNS.
Just because there is some chart on the internet, does not mean its a standard. I think they need to put a little asterick beside what they have listed for the 1 5/8 and 1 7/8 cause there is NO UNC or UNF for those sizes.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!