Inventor General Discussion

Inventor General Discussion

Reply
New Member
syed.izhar89
Posts: 1
Registered: ‎03-17-2014
Message 1 of 1 (65 Views)

regarding the reliefs for the modelling of shafts

65 Views, 0 Replies
03-17-2014 03:31 AM

hi,

  while modelling the shafts if the shaft is turned down, and diameters A and B are given, and if a-b<.1875, we generally give the fillet of .25 follwed with 45 deg angle and .13 fillet again to provide the reliefs, could you please let me know like is there any option in inventor to give the reliefs so that we wont forget for providing the relief detail in the model.

 

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.