Inventor General Discussion

Inventor General Discussion

Reply
Mentor
CAD-One
Posts: 760
Registered: ‎10-26-2008
Message 1 of 3 (180 Views)
Accepted Solution

Reference part not obeying HLR optin in drawing

180 Views, 2 Replies
06-21-2012 10:13 AM

I am in a IDW for an assembly file. burried deep inside , there is a part that need to be present in assembly (But in reference BOM condition)

 

When I insert a view with HLR option, why this part visible in dashed line. Whereas it supposed to Not Showup at all?

 

Example : Say I have a assembly of a spheres dia 5in & dia 3in (assembled center on center). The smaller sphere is in reference BOM mode. In the drawing view with Hidden Lines Removed option why is the smaller sphere visible in hidden line?

 

 

C1
Inventor Professional 2015
Vault Professional 2015

capture.jpg

 

Edit: You probably want to check the "As Parts" option to the left of it as well to get normal behaviour out of it.

*Expert Elite*
mrattray
Posts: 2,507
Registered: ‎09-13-2011
Message 2 of 3 (172 Views)

Re: Reference part not obeying HLR optin in drawing

06-21-2012 11:32 AM in reply to: CAD-One

capture.jpg

 

Edit: You probably want to check the "As Parts" option to the left of it as well to get normal behaviour out of it.

Mike (not Matt) Rattray

Mentor
CAD-One
Posts: 760
Registered: ‎10-26-2008
Message 3 of 3 (165 Views)

Re: Reference part not obeying HLR optin in drawing

06-21-2012 12:35 PM in reply to: mrattray

Thanks for the solution. :smileyhappy:

C1
Inventor Professional 2015
Vault Professional 2015
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.