Inventor General Discussion

Inventor General Discussion

Reply
Contributor
enfiel3d
Posts: 13
Registered: ‎01-22-2006
Message 1 of 2 (278 Views)

Reference dimensions in the iPart table

278 Views, 1 Replies
08-14-2011 01:08 AM

Greetings!


The question I want to ask is about reference dimensions in iPart.


I can create a sketch and place reference dimensions on it, there's no problem. I can activate any configuration manually and see the reference dimensions adjusted according to configuration, no problem again.
I would like to know — is it possible to automatically populate column of the iPart table with reference dimension value, as it stands for each configuration?
I was able to find some solution for that, but it's not automatic. I can mark reference dimension of export, and add it as a column to the table, but I need to manually activate each configuration to populate the column with measured reference value. Not very good, because there can be very many configurations.

Any ideas as of how to automatically get complete list of reference dimensions values for each configuration of the iPart?

Active Member
Oesh01
Posts: 15
Registered: ‎08-27-2007
Message 2 of 2 (229 Views)

Re: Reference dimensions in the iPart table

12-02-2011 01:42 PM in reply to: enfiel3d

Great question.  Will someone please address this issue.  We are using Inventor 2012 and we are having the same problem with getting a reference dim to populate into the family table.  We need this value for our production drawings.

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.