Inventor General Discussion

Inventor General Discussion

Reply
Member
xyz1982
Posts: 3
Registered: ‎12-28-2011
Message 1 of 1 (386 Views)

Rectangular plate natural frequency problem

386 Views, 0 Replies
02-27-2013 08:30 AM

Hi.

 

I have a problem with the results gained from a natural frequency simulation on a rectangular plate. The results gained are completely different to the ones obtained for the same plate through the theoretical equations. I would be very grateful if someone could take a look at the Inventor file and let me know what I am doing wrong.

 

I have attached a Microsoft Excel file with the results from the theoretical equations using the same material properties. (The frequencies are in rad/s in the Excel spreadsheet whereas they appear in Hz in Autodesk.)

 

The corresponding equations used can be found in the Word file.

 

I am very grateful for your help. Please ask if you need more information or have questions.

 

Thanks,

Sam

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.