Inventor General Discussion

Reply
Active Member
narzinski04
Posts: 7
Registered: ‎01-25-2012
Message 1 of 2 (89 Views)

rebuild/update error

89 Views, 1 Replies
05-14-2012 08:17 AM

I have a parameters only part which drives the parts in an assembly.  When I change the parameters and go back into the assembly I am getting an error.  I can accept the error and drag the parts around and they snap into place, which ends the error.  It works, but isn't very appealing to the eye.  Is there any way to fix this?

using inventor 2011

 

Thanks,

Nick

Valued Mentor
Rich.O.3d
Posts: 526
Registered: ‎08-19-2008
Message 2 of 2 (64 Views)

Re: rebuild/update error

05-14-2012 03:29 PM in reply to: narzinski04

adaptive parts and assemblies built with mates dont play nice

 

I would use skeleton modeling

CAD Management 101:
You can do it your own way,
If its done just how I say!
[Metallica:And Justice For All:1988]
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.