Inventor General Discussion

Inventor General Discussion

Reply
New Member
loganmapes
Posts: 2
Registered: ‎11-30-2012
Message 1 of 4 (167 Views)

Ratio

167 Views, 3 Replies
11-30-2012 09:45 PM

How do you change the ratio size of a part. I have a part and made it just a bit smaller than the constraints say. I want to up the ratio of it. How?

*Expert Elite*
Dan.M
Posts: 618
Registered: ‎01-19-2009
Message 2 of 4 (150 Views)

Re: Ratio

12-01-2012 03:24 AM in reply to: loganmapes

Hi,

Do you mean like scale down a part?

Lets say make it 10% smaller then what it is now.

 

Dan

New Member
loganmapes
Posts: 2
Registered: ‎11-30-2012
Message 3 of 4 (133 Views)

Re: Ratio

12-01-2012 01:56 PM in reply to: Dan.M

Yeah! Exactly. Do you know how to do that? If you do could you explain how? Thanks!

*Expert Elite*
JDMather
Posts: 28,228
Registered: ‎04-20-2006
Message 4 of 4 (131 Views)

Re: Ratio

12-01-2012 02:53 PM in reply to: loganmapes

Start new part file.

Select Derived Component and the original file.

Set the scale factor.

 

If you have Inventor Tooling there are additional tools for scaling.


I think there is also a scale tool in the SDK that allows independent scaling for each axis.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.