Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
schnautza
Posts: 155
Registered: ‎03-13-2013
Message 1 of 2 (422 Views)
Accepted Solution

"Unable to create component" from content center

422 Views, 1 Replies
10-18-2013 01:32 PM

Today, all of a sudden, my coworkers and I cannot place standard parts from our content center (there are only three of us). We are not using Vault - but we have set up our Content Center to access a network location:

 

N:\Standards\Inventor\Content Center Files\Libraries\

 

This has worked for months ever since we set it up. Problems just started today for all of us. Parts that DO work are parts that you have to tell it an extruded length (like structural steel or tube/pipe). Nothing else will work (fasteners, pipe fittings, shaft collars, etc).

 

Interestingly, if I select to insert the part "as custom" instead of "as standard", all parts work like they should.

 

For the parts that do not work, I can navigate through all of the menus to select parts, but instead of getting the "Save As" dialogue, I get the "Unable to create component" error message.

 

What's going on?

Never mind - I figured out the problem.

 

Our IT department set the 'Standards' folder to read-only...which meant the content center could not write any parts to it's location. I had them give the couple of Inventor users full read/write access to that subfolder, and it is back to normal.

Valued Contributor
schnautza
Posts: 155
Registered: ‎03-13-2013
Message 2 of 2 (419 Views)

Re: "Unable to create component" from content center

10-18-2013 02:02 PM in reply to: schnautza

Never mind - I figured out the problem.

 

Our IT department set the 'Standards' folder to read-only...which meant the content center could not write any parts to it's location. I had them give the couple of Inventor users full read/write access to that subfolder, and it is back to normal.

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.