Inventor General Discussion

Inventor General Discussion

Reply
Product Support
bobvdd
Posts: 570
Registered: ‎11-23-2005
Message 21 of 23 (84 Views)

Re: Question regarding IV2013 improvements

06-18-2012 02:53 PM in reply to: acad-caveman

Weird. I don't see the conversion to spline after breaking the link of the projection.

 

Anyway, talking about the bigger scheme of things, our developers are looking into this and you can refer to this defect number to obtain further status on this issue:

 

Defect 1464270 The hole in a cylinder shown as a spline and not as a circle after dwgout

 

Bob

Distinguished Contributor
acad-caveman
Posts: 165
Registered: ‎08-21-2009
Message 22 of 23 (78 Views)

Re: Question regarding IV2013 improvements

06-18-2012 03:29 PM in reply to: bobvdd

Bob, thank you again.

 

I've attached another version of the resulted Autocad DWG, showing the spline which I've tortured a little to indicate it.

Also, what I've discovered in the process is that only the visible circle turns into a spline.

I've changet the through hole into a blind one and created a front an back view of it.

In the front view the hole became 2 separate splines on the visible layer, while in the back view it remained one true circle on the hidden layer.

 

Product Support
bobvdd
Posts: 570
Registered: ‎11-23-2005
Message 23 of 23 (68 Views)

Re: Question regarding IV2013 improvements

06-18-2012 04:32 PM in reply to: acad-caveman

I think I now see what is going on. Looks like 2012 and 2013 react differently. 

 

In 2012, breaking the projected "circle" results in a spline

In 2013, I get a true circle after breaking the projection.

 

Bob

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.