Inventor General Discussion

Inventor General Discussion

Reply
Contributor
schwebby
Posts: 13
Registered: ‎05-20-2009
Message 1 of 3 (240 Views)

Question about live library parts

240 Views, 2 Replies
08-18-2010 07:19 AM

I was wondering if it is possible to have a live .iam as a library part?  By live I mean an .iam that is adaptive and uses a contact set as a travel limiting constraint - as in a drawer slide.

 

Thanks

**Master
BMiller63
Posts: 2,533
Registered: ‎01-28-2009
Message 2 of 3 (230 Views)

Re: Question about live library parts

08-18-2010 09:40 AM in reply to: schwebby

I doubt it with Adaptivity, but I think you could with positional reps, if you set it all up ahead of time, or make edits and saves in a separate project that does not list the file's location as a library, then you can, but you'll bump into read-only notices when trying to switch between reps.

 

If I were you, I'd just create a test assembly to find out what you run into.

*Pro
Dennis_Jeffrey
Posts: 1,369
Registered: ‎12-15-2003
Message 3 of 3 (218 Views)

Re: Question about live library parts

08-18-2010 11:10 AM in reply to: schwebby

If you place the iam into a designated project  library folder, then you cannot make edits to the iam.

Please mark this response as "Accept as Solution" if it answers your question.
____________________________________________________________
Dennis Jeffrey, Author and Manufacturing Trainer, Autodesk Inventor Certified Expert
Autodesk Manufacturing Implementation Certified Expert
Autodesk Silver Manufacturing Partner

Subscribe to the free digital "The Creative Inventor Magazine" now available at: http://teknigroup....

XP64 SP2, GeForce 9800GT-1GB, Driver: 6.14.12.7061, 8GB Ram, AMD Athlon II 3.2 Ghz
Laptop: Win7-64 Pro, 4GB, ATI Graphics on board, 2012 Ultimate, IV2011 or 2010 Pro, all SP's
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.