Inventor General Discussion

Inventor General Discussion

Reply
Member
rodrigotito
Posts: 4
Registered: ‎11-21-2011
Message 1 of 2 (64 Views)

Publish Frame Content Center

64 Views, 1 Replies
04-17-2012 07:40 AM

I am trying to publish a profile in my library and I can not.
The difference I noticed is that now I'm working on sheet metal environment and sometimes it was in part.

In the process get an error stating that there is a point in the design of extrusion ... Only if I can publish my piece is an extrusion?

Attached is the part that I can not publish

 

Thanks!

 

Inventor 2012

*Expert Elite*
Curtis_Waguespack
Posts: 3,002
Registered: ‎03-08-2006
Message 2 of 2 (61 Views)

Re: Publish Frame Content Center

04-17-2012 07:52 AM in reply to: rodrigotito

Hi rodrigotito, 

 

Rob Cohee has a video on the subject of publishing sheet metal components to use in Frame Generator:

 

http://youtu.be/1Ff9yIVNAa4

 

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com




  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.