Inventor General Discussion

Reply
Member
mello
Posts: 3
Registered: ‎09-12-2003
Message 1 of 1 (71 Views)

project geometry

71 Views, 0 Replies
09-12-2003 05:57 AM
Now when I open a new part and choose any sketch tool, the center point immediately shows and I cannot sketch anything. I am not sure what I have done to make this happen. It doesn't go away when I close and reopen the program. What have I done?
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.