Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Problems with sweep on curve..Possible? (Picture)

2 REPLIES 2
Back to Inventor Category
Back to Topic Listing
Reply
Message 1 of 3
OliverTat
Contributor
344 Views, 2 Replies
‎01-19-2011 01:32 AM
‎01-19-2011 01:32 AM

Problems with sweep on curve..Possible? (Picture)

Hello everyone,

 

I have a slight issue with a profile I am drawing!

 

On the top surface It needs a ellipse curve, but on the end of the chair has a profile/detail already on..

 

Basically as per picture attached, what are my options?!

 

Regards

 

 

Preview file
67 KB
Report
0 Likes
Reply
2 REPLIES 2
Message 2 of 3
sam_m
Advisor
in reply to: OliverTat
‎01-19-2011 03:06 AM
‎01-19-2011 03:06 AM

tried a loft?  Probably will have to do as a surface and then sculpt it into a solid after.

 

use the existing side edges as rails and possibly add a new rail along the centre showing how you want the middle of the bottom face blending into the middle of the top face.



Sam M.
Inventor and Showcase monkey

Please mark this response as "Accept as Solution" if it answers your question...
If you have found any post to be helpful, even if it's not a direct solution, then please provide that author kudos - spread that love 😄

Report
0 Likes
Reply
Message 3 of 3
OliverTat
Contributor
in reply to: sam_m
‎01-19-2011 03:12 AM
‎01-19-2011 03:12 AM

Humm,

 

I seem to have muddled through it now, I made the whole end piece square and just cut away from a side.

 

Report
0 Likes
Reply
Reply

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report

Report a website issue