Inventor General Discussion

Inventor General Discussion

Reply
New Member
monkey20
Posts: 2
Registered: ‎01-03-2013
Message 1 of 4 (317 Views)

Problems with insert constraint with inventor 2011

317 Views, 3 Replies
01-03-2013 12:04 PM

I am having a problem with the insert constraint. once the object is inserted it will not spin inside the hole.

*Expert Elite*
blair
Posts: 4,471
Registered: ‎11-13-2006
Message 2 of 4 (309 Views)

Re: Problems with insert constraint with inventor 2011

01-03-2013 01:25 PM in reply to: monkey20

If other items are selected (hi-lighted in the browser) it will stop the item from spinning. Sometimes items are copied in and just act funny. Delete them, do a save and re-install them and everything works fine.

 

Have yet to figure it out. Or just a good old complete power down, wait and power up the system.

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 344.75
SpacePilot Pro 10.2.0 / 17.2.0.11011 / 4.17
Delta Tau Chi ΔΤΧ
*Expert Elite*
JDMather
Posts: 28,238
Registered: ‎04-20-2006
Message 3 of 4 (299 Views)

Re: Problems with insert constraint with inventor 2011

01-03-2013 05:02 PM in reply to: monkey20

Attach the assembly here that exhibits this behavior (need only the two parts involved with this behavior).

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
New Member
monkey20
Posts: 2
Registered: ‎01-03-2013
Message 4 of 4 (279 Views)

Re: Problems with insert constraint with inventor 2011

01-04-2013 10:43 AM in reply to: blair

I tried what you suggested but it still did not work. Do you have any other ideas?

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.