You have SP1 installed for IV2008, was all the Anti-Virus software disabled
on the install of IV. Some versions require the A/V service to be stopped.
--
Dell 670 dual Xeon - 3.2
3gb memory, SCSI320-15k
XP-Pro, sp2
Quadro FX3400: Driver: 169.61 Direct3D
IV2008-pro sp2,
SpacePilot Rel V: 3.6.4 Dvr V: 6.5.5 Firmware 3.12
wrote in message news:5921838@discussion.autodesk.com...
For some reason the program crashes everytime I try to create a part. I can
sketch just fine but when I try to revolve or extrude the program crashes.
No clue what's going on. MDT works fine.