Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Problems trying to place horizontal dims - SP2 related
Problems trying to place horizontal dims - SP2 related
This has happened since installing SP2.
I have a view on a drawing, on some of the vertical lines, with the general
dimension button pressed I no longer get the glyph with the left and right
arrows when hovering over a line (the lines only go red). It's not all of
the lines but the ones that I want to put a horizontal dimension between!
As a work-around I'm having to pick endpoints and then specify that it's a
horizontal dimension.
I have seen dimension trouble back to IV5. I usually just cancel the
command and start over and things work correctly.
Jeff Hess
"Rob Singlehurst" wrote in message
news:9634BBCB28A103701FCEBAE11FF9BA67@in.WebX.maYIadrTaRb...
> Yep, it's not on all of the lines all of the time - might just be a
peculiar
> assembly or something.
>
> --
> Cheers,
>
> --Rob Singlehurst
>
>
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")