Inventor General Discussion

Inventor General Discussion

Reply
New Member
ninjamike28
Posts: 2
Registered: ‎04-12-2012
Message 1 of 3 (269 Views)

PROBLEM WITH A SHELL

269 Views, 2 Replies
04-12-2012 07:15 AM

For a while now, I've been trying to shell a split game controller that will create the bottom part of the casing. However, every time I try to shell, a problem occurs "Modelling failure in ASM. Redefine inputs".

 

I've tried to find the source of the problem through supressing features, and when it finally does shell, the casing creates another problem that will not allow me to loft to get the proper appearance.

 

Please help as this is a project to be handed in by next week.

 

:smileyfrustrated:

*Expert Elite*
JDMather
Posts: 27,429
Registered: ‎04-20-2006
Message 2 of 3 (267 Views)

Re: PROBLEM WITH A SHELL

04-12-2012 07:26 AM in reply to: ninjamike28

I recommend that you start over using what you learned from your this attempt.


You might read this document http://home.pct.edu/~jmather/skillsusa%20university.pdf

and make use of obvious symmetry about the origin. (your origin centerpoint is not in a logical location)

 

You know in the end that the part will be shelled.
Knowing that - attempt Shell after each feature (don't want to get hours invested only to find that it won't shell).

 

If I drag the red End of Part marker just below Loft1(your very first feature) and attempt to shell - it fails on your very first feature.

 

If you run into trouble on your next attempt with the first feature - post back for suggestions on how to fix it.

There are a number of (older) tutorials in my signature.

 

 

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
New Member
ninjamike28
Posts: 2
Registered: ‎04-12-2012
Message 3 of 3 (233 Views)

Re: PROBLEM WITH A SHELL

04-16-2012 04:34 AM in reply to: JDMather

Ok thanks, I'll look into it and hopefully it works :smileyhappy:

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.